How to choose a flood barrier

Flood barriers are used in a variety of water retaining areas. As long as the requirements for use are met, especially in the rainy season, the frequency of use will be higher. Now many places are inseparable from the use of flood control barriers.

There are two kinds of flood control barriers, one is aluminum alloy flood control barrier, and the other is stainless steel flood control barrier. Aluminum alloy flood control barrier is often used in underground garage entrance, underground shopping mall entrance, subway entrance and exit and other places prone to flooding, is one of the more widely used flood control barriers, can meet the needs of water and flood control in cities and other places.

Aluminum alloy flood barrier:

According to the size of the installation site, the price of aluminum alloy flood control barrier on the market is about 1200/㎡.

Accurate measurement of flood barriers: Determine the position of two side columns, a pair of side columns (middle columns) need to be kept straight and marked. Clean the dust and garbage at the corners, sweep the walls and corners, and there must be no debris on the contact surface of the column.

Stainless steel flood barrier:

In addition to aluminum alloy flood control barriers, more stainless steel flood control barriers are used. Stainless steel flood barrier is more expensive in the market, about 1500/㎡.

Product installation method:

After the flood control barrier is installed and used, pay attention to take out the flood control barrier and the middle column in turn, and pay attention to leaving the screw at the bottom of the middle column on the embedded parts to prevent dust from falling into the screw hole and affecting the use. Then place the rubber strip of the flood barrier up on the wall hanger and put it away.

When installing the flood barrier, it should be placed in parallel and clamped sequentially, pay attention to the last plate of the rubber strip should be placed below, and install the top pressure piece, and then use a hex wrench to tighten the hex screws on the top and side of the column in turn until it cannot be tightened.

The stainless steel flood control barrier column is made of stainless steel, and the flood control barrier (flood control barrier) is made of special aluminum alloy, which has high strength and can resist long-term flood immersion and high-strength water pressure. If flood control is required during flood season, facilities can be quickly assembled at the gates. When the water level is low, the assembled flood wall can be removed.